Flying Gadgets Flight 2 Channel Series Buku Petunjuk - Halaman 6
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mainan Flying Gadgets Flight 2 Channel Series. Flying Gadgets Flight 2 Channel Series 6 halaman.
The aeroplane is made of very crash resistant materials. Minor damages can be easily repaired with selotape. Cracks or large damage needs
to be repaired using glue.
For spare parts please contact your local dealer or Flying Gadgets Ltd
Glue instructions:
Clean and dry the broken parts rst, apply the glue evenly over both surfaces. In order to
get the best gluing e ect, stick both of the sufaces together then seperate them until the
glue drys slightly (2 minutes). Then join them back together again and leave to dry for
about 2 hours.
Propeller doesn't work
The aeroplane keeps spinning or falls out the sky
after take o
Can not take o
Aeroplane doen't take o
No response to the controller or doesn't respond
correctly to the controller
Loosing control of the aeroplane
1. This product is a remote controlled aeroplane. It can be damged in a crash or collision. Our warrenty does not cover any damge due to
accidents or collisions.
2.If you crash the model and need spare parts you can purchase them from your local dealer or direct from Flying Gadgets Ltd.
3. We reserve the right to change the content or parts without notice.
4. The contents of this manual has been checked thoroughly and have no responsibility for any errors or omissions.
5. Pictures in this instruction manual are only for reference.
Assembling the propeller:
When replacing the propellor you will have to
remove the front cowling and the propellor by
carefully turning it.
Not trimmed
Not taking o toward the wind
low battery
Not enough speed during take o
Interference by a power line or another
device on the same frequency
A device on the same frequency close
by. Or out of range of the aeroplane
Take o towards the wind
Recharge battery
Use a faster take o speed
Fly the aeroplane somewhere else
Operate somewhere else
Operate within 60m range