Astro Pneumatic Tool 1426 Petunjuk Manual - Halaman 2
Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Alat Keling Astro Pneumatic Tool 1426. Astro Pneumatic Tool 1426 7 halaman. 1/4" heavy duty hand riveter
Halaman Cetak
The heavy duty riveter has 5 different size nose
pieces to fit the following size rivets: 1/8", 5/32",
3/16", 7/32", and 1/4". They are located 2 on each
side of the handles in PHOTO1-A. This set should
also include nose piece wrench as shown in
PHOTO 1.
PHOTO 1
TO CHANGE THE RIVETER NOSE PIECES:
1. Select the proper size desired.
2. Simply remove and replace the one located on the
end of the extension as shown in PHOTO 2
with the wrench supplied.
PHOTO 2
A
1426
1/4" HEAVY DUTY HAND RIVETER
• Extra long handles provide excellent leverage
• Includes 5 nosepieces: 1/8", 5/32", 3/16", 7/32", 1/4"
• Tool length 20-3/4"
• Spent mandrels are collected in the plastic container
for safety and ease of disposal
1/4" HEAVY DUTY HAND RIVETER
TOOL OPERATION:
1. To install a rivet, open the handles outward
as far as they will go.
2. Put the desired size rivet in the end that
corresponds with the installed nose piece.
3. With the handles spread wide, push the rivet into the
pre-drilled hole and put a slight amount of pressure
on the rivet and work piece. Then squeeze the
handles together until the rivet head pops loose
form the mandrel.
4. Sometimes one squeeze will not be sufficient to
separate the rivet from the mandrel as longer and
larger diameter rivets may require more than
one squeeze.
5. Re-spread the rivet handles and slide the
nose piece against the rivet button and squeeze
once again till the rivet pops loose from
the mandrel.
When breaking lose the riveter from the
rivet, please assume a firm stance as you
may loose your balance which could
result in serious injury.