Astro Pneumatic Tool 4008 Panduan Memulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Penyemprot Cat Astro Pneumatic Tool 4008. Astro Pneumatic Tool 4008 4 halaman.

Halaman Cetak

MODEL:

OPERATION

1. Operating the spray gun

• This air operated spray gun is designed to perform a variety

of painting, coating, and finishing applications using the

power of compressor air.

• Do not exceed the maximum air pressure of 60 psi.

• The trigger lever of this gun has a two-step design. Press the

trigger lever to the first step to connect to the air source,

ensuring that air flow fills the spray gun.

Press the trigger lever to the second step to connect the paint

material.

2. Controlling the pattern and fluid flow

• Adjust the air pressure with the trigger pulled and the air

control knob fully open. If reduced air pressure is desired for

some areas of the spray job, use the air compressor regulator

or air control to reduce pressure as necessary.

• Increase the air flow by turning the air control knob

clockwise. Reduce the air flow by turning the air control

knob counterclockwise.

• Set the pattern size to the desired shape. For a full pattern,

turn the pattern control knob counterclockwise. For a round

pattern, turn the pattern control knob clockwise.

• Turn the fluid control knob fully clockwise until closed to

control the fluid.

4008

Pattern Control

Knob

(1)

Fluid Control

Knob

(2)

Air Control

Knob

(3)

PRODUCT TYPE:

SPRAY GUN WITH CUP

RED HANDLE 1.8MM NOZZLE

• The direction of the fan (horizontal or vertical) can by adjusted

by loosening the air cap ring and turning the air cap 90 degrees.

• Trigger a short burst while turning the fluid control knob

counterclockwise. Observe the spray pattern on the target and

adjust the fluid control knob until the desired atomization is

achieved.

3. Preparing and loading the paint

• Thoroughly mix and thin the paint in accordance with the paint

manufacturer's instructions. Most materials will spray readily if

thinned properly.

• Strain the material through cheese cloth or a paint strainer.

• Fill the paint canister to the maximum of the 3/4 full capacity

carefully.

• Set up a piece of cardboard or other scrap material to use as

a target. Adjust the spray gun for the best spray pattern and the

best atomization option.

• Test the consistency of the material by making a few strokes on

a cardboard target. If the material still appears too thick, add a

small amount of thinner. THIN WITH CARE!! Do not exceed

paint manufacturer's thinning recommendations.

Page 2

Air Cap

(1)

Air Cap Ring

(2)

Horizontal Fan

(3)

Vertical Fan

(4)

Paint too ne

(1)

Correct

(2)

Paint too coarse

(3)