Astro Tool M22520/40-01 Perakitan - Halaman 3

Jelajahi secara online atau unduh pdf Perakitan untuk Alat crimp Astro Tool M22520/40-01. Astro Tool M22520/40-01 6 halaman. For terminals, splices, and endcaps

Halaman Cetak

INSULATION CRIMP ADJUSTMENT

Each tool has four insulation crimp positions.

(See Figure 1) To set the Insulation Crimp Height:

1. Loosen the insulation adjustment locking

screw, and turn the indicator to position 4.

(See Figure 1)

2. Load the terminal or splice into the crimp

cavity.

3. Insert an un-stripped wire into ONLY the

insulation barrel of the terminal or splice.

4. Perform a crimp, and remove the crimped

terminal or splice.

5. Bend the wire back and forth once. The

terminal or splice should retain a grip on

the wire insulation.

6. If the wire pulls out, adjust to the next

descending insulation crimp position.

7. Perform another crimp, and recheck the

wire grip.

8. Repeat the adjustment as necessary until

wire is gripped. DO NOT use a tighter

setting than required.

GAGING THE CRIMP CAVITIES

MS Part Number

M22520/43-01

M22520/43-02

M22520/43-03

M22520/43-04

______________________________________________________________________________________________

TI4001

ASTRO TOOL CORP.

CONNECTOR ASSEMBLY TOOLING

Astro Part

Number

AMTG4301

AMTG4302

AMTG4303

AMTG4304

21615 SW T-V Hwy, Beaverton, OR 97006 USA

Phone: 503-642-9853 Fax: 503-591-7766

9. Retighten the insulation adjustment locking

screw.

INSPECTION AND GAGING

Astro recommends the user inspect and gage the

tool periodically to ensure dependable and

uniform terminations. Frequency of inspection

and gaging is determined by the end user to suit

their requirements through experience.

Frequency of inspection and gaging is dependent

upon:

1. The care, amount of use, and handling of

the tool.

2. The type and size of the products being

crimped.

3. The degree of operator skill.

4. The presence of abnormal amounts of

dust, and dirt.

5. The user's own established standards.

Gage Type

GO/NO-GO

Page 3 of 6

Astro Tool Corporation

Wire Size

(AWG)

22-16

Red Conductor

16-14

Blue Conductor Cavity

22-16

Red Insulation

16-14

Blue Insulation

REV. A

Gage Area

Cavity

7-9-08