Astro Tool M22910/7-1 Panduan Memulai Cepat
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Alat crimp Astro Tool M22910/7-1. Astro Tool M22910/7-1 3 halaman. Connector assembly tooling cycle controlled c-frame style crimp tool
Halaman Cetak
CYCLE CONTROLLED C-FRAME STYLE CRIMP TOOL
612648 (M22910/7-1) AND ASSOCIATED TYPES
INSTRUCTIONS FOR USE OF 612648 HEX POP-IN DIE CRIMP TOOL
GENERAL:
The Astro Tool Corp. Hex Pop-in Die Crimping Tool
is a cycle controlled, manually operated, C-frame tool for
crimping shield terminating ferrules, RF connector
fittings, and other terminations requiring an open frame
crimp tool.
There is only one set up operation required - installing
the required die set. Die sets are available in single,
double and triple hex cavities. Special form crimps are
also obtainable, consult the factory for details.
The Tool's precision cycle control mechanism assures
a high quality, repeatable crimp. The in-line action of the
dies and toggle mechanism reduces the compression force
required to complete the crimp.
For long life and optimum performance, this tool
should be kept clean and handled with the care of any
other precision device.
OPERATION
ASTRO TOOL CORP.
CONNECTOR ASSEMBLY TOOLING
a. Open and close the tool several times and observe
the precision cycle-control mechanism. Note that the tool
cannot be opened without completing its cycle.
b. Identify the parts in figure #1:
1. Ratchet Handle
2. Movable Die Nest
3. Housing Cleat
4. Stationary Die Retaining Detent
Housing
Cleat
Stationary
Die Retaining
Detent
c. Die Installation
1
Movable
Die Nest
Ratchet
Handle
Figure #1
2-11-93 TI648-93-0