Astro-Gadget AZStarPRO Panduan Pengguna - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengontrol Astro-Gadget AZStarPRO. Astro-Gadget AZStarPRO 10 halaman. Azimuth mounts control system
Halaman Cetakmode, hold down the "MODE" button located on the side of the joystick and turn
on the power. When AZStarPRO is switched on in settings mode, two short beeps
should sound. If the settings do not match the desired settings for the mount, set
and save the correct settings.
Attention: For the "AZStarPRO setting" application to work, Framework 4.0 and
vs2013 redistributable x86 and x64 must be installed on the computer.
4. PC CONTROL (AUTOMATIC OBJECT SEARCH (GoTo mode)
Before starting to work in this mode, the PC must be installed
ASCOM platform, ASCOM driver for the SynScan app and the SynScan
application itself. The telescope mount should be level and the telescope tube
should be horizontal to the north.
After turning on the power, 1 long, 3 short and 1 long beeps should sound,
indicating that the AZStarPRO is ready to operate the mount.
Next, download the SynScan application and in the settings select the interface
(network or serial port) that will be used for connection AZStarPRO from PC...
Then, in the SynScan application, click the "Connect" button to establish
connection with AZStarPRO. If the AZStarPRO connection with by the SynScan
application happened successfully, then you can proceed to aligning the mount
with bright stars. After successfully aligning the mount with the bright stars, you
can connect to the planetarium program. At the same time, the SynScan
application must remain loaded. In the planetarium program on the PC, select the
SynScan app driver telescope in the ASCOM menu and connect to it.