ASTRO-MED Dash 10 Panduan Memulai Cepat - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Alat Ukur ASTRO-MED Dash 10. ASTRO-MED Dash 10 14 halaman.
STORING CHARTS
AND SETUPS
• Turn the encoder wheel until 40mm is selected. This selects a chart location
which can range from 1 to 250 mm where 1mm is near the bottom (right) and
250mm is near the top (left).
• Press the soft key below "MAJORS".
• Turn the encoder wheel until 10 is selected. There will be 10 major divisions in
your grid.
• Press the soft key below "MINORS".
• Turn the encoder wheel until 2 is selected. There will be 2 minor divisions
between each major division.
Congratulations! You have now made a custom grid for channel 2. Press the
[RUN/HALT] key to start the chart.
It is important to understand that there is a difference between charts and modes.
Basically, a chart is the way information is presented on the paper, such as: text
location, event location, wave location, waveform width and grid on/off.
A setup consists of t he specific parameters used in a recording setup, as well as the
soft key chart settings. These parameters include: zero and gain settings, speed settings,
edit settings and trigger settings. Setups are saved to floppy disk.
(See the Operations Manual for information on how to save modes.)
Let's demonstrate how charts are saved to soft keys.
• Press the [RUN/HALT] key to halt the chart.
• Press the [MODE] key. The MODE menu will appear.
• Press the soft key above "CHART 1 - ASTRO 1". The default chart Astro 1
saved under this soft key will be running. Notice the layout of the chart.
• Press the [RUN/HALT] key to halt the chart.
• Press the [SYS] key. The SYS menu will appear.
• Press the soft key above "MODIFY CHART". The MODIFY CHART me nu will
appear
• Press the soft key above "CHANGE GRID". The CHANGE GRID menu will
appear.
• Press the soft key above "LAYOUT GRIDS". The LAYOUT GRIDS menu
will appear.
• Press the soft key above status until it reads off. Make sure the grid s for all the
channels have the status set to off.
• Press the [MODE] key. The MODE menu will appear.
• Press the soft key above "CHART 1 - ASTRO 1". Notice that now the grid is off.
• Press the [RUN/HALT] key to halt the chart.
The Dash 10 automatically saves the chart to the soft key that you were previously
running.
6