Canon 2746B002 Panduan Memulai Cepat - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Lensa Kamera Canon 2746B002. Canon 2746B002 18 halaman. Ultrasonic image stabilizer

Halaman Cetak

a Safety Precautions

• Do not look at the sun or a bright light source through the

lens or camera. Doing so could result in loss of vision. Looking

at the sun directly through the lens is especially hazardous.

• Do not point the lens or camera at the sun or photograph

it. This is because the lens concentrates the sun's rays even

when the sun is outside the image area or when shooting

with backlight, which could cause malfunction or fire.

• Whether it is attached to the camera or not, do not

leave the lens under the sun without the lens cap

attached. This is to prevent the lens from concentrating

the sun's rays, which could cause a fire.

• Do not stand on the lens case. Falling off the case

could result in injury.

• Do not stack lens cases. A falling lens case could

cause an injury.

Handling Cautions

• If the lens is taken from a cold environment into a

warm one, condensation may develop on the lens

surface and internal parts. To prevent condensation in

this case, first put the lens into an airtight plastic bag before

taking it from a cold to warm environment. Then take out

the lens after it has warmed gradually. Do the same when

taking the lens from a warm environment into a cold one.

• Do not leave the lens in excessive heat such as in a

car in direct sunlight. High temperatures can cause

the lens to malfunction.

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.

Do not make any changes or modifications to the equipment

unless otherwise specified in the instructions. If such changes or

modifications should be made, you could be required to stop

operation of the equipment.

This equipment has been tested and found to comply with the

limits for a class B digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications.

However, there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of

the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Consult the dealer or an experienced radio/TV technician for

help.

This Class B digital apparatus complies with Canadian ICES-003.

ENG-2