ASTRO-PHYSICS 1568GTO Panduan Petunjuk Pemeliharaan - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemeliharaan untuk Papan tombol ASTRO-PHYSICS 1568GTO. ASTRO-PHYSICS 1568GTO 17 halaman.

Closing the Keypad

When placing the back onto the unit, make sure the screws are aligned with the proper holes. start by aligning the two

screws on one side of the display. the four screws on the display end must pass through the display circuit board before

engaging in their posts.

make sure that all wires, fibers and cables will be safely inside the unit.

if you have unplugged anything, be sure that it is correctly plugged

back in.

note the spacer washers in place on their screws!

1. line up the display end before moving to the cable end of the

keypad.

2. the cable strain relief may need to be held and guided gently

into the cutout in the case to finish mating the two halves.

Make a final check to be sure that no wires, fibers or

cables are caught between the front and back halves of

the keypad.

3. carefully apply a small amount of pressure to hold the back down while

tightening all six screws.

4. Reinstall your keypad protector (KeYPRo) using the instructions refer-

enced earlier.