AIR GUARD AG-850 Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk Alat penguap AIR GUARD AG-850. AIR GUARD AG-850 16 halaman. Antibacterial vaporizer

Follow the steps below to pair or delete a transmitter from receiver.

Step 1: Turn on machine

Step 2: Press [A] or [B] button within 15 seconds to register

To register multiple transmitter follow step above and press [A] or [B] button on all registering

transmitter within 15 seconds after power is turn on. When new transmitter is registered previous

transmitter will be automatically deleted.

Transmitter battery replacement

If the effective distance seems to decrease, it is possible the battery level is low and requires

replacement. In order to replace the battery, undo the three screws on the back of transmitter to

release the cover. Replace with the same type and specification of battery which is 27A 12V

Fluid

Service and Maintenance

Do not allow the machine to become contaminated.

․

Remove dust from air vents with air compressor, vacuum or a soft brush.

․

Only use a damp cloth to clean the casing.

․

Before storing run distilled water through the system to help prevent condensing the pump or

․

heater.

It is recommended to run the machine on a monthly basis in order to achieve best

․

performance and output condition.

Excessive dust, liquid and dirt built up will degrade performance and cause overheating.

․

Fuse Replacement

Disconnect AC power before resetting the breaker. Only replace fuse with same type

and rating.

Step 1: Disconnect AC power.

Use Air Guard FLE-G for AG-850. The machine is tested and

calibrated with authorized fluid to achieve the best performance.

Warranty will be void, if any other type of liquid is used. Improper

use of liquid may lead to machine failure and danger.