Astrol Electronic BAT-FLEX Manual - Halaman 4

Jelajahi secara online atau unduh pdf Manual untuk Alat Ukur Astrol Electronic BAT-FLEX. Astrol Electronic BAT-FLEX 19 halaman.

2.2. Remarks



Keep in mind that the BatFlex system uses a static IP Version 4 configuration. This requires the user to choose an IP

separately for each device.



The IP is updated as soon as the configuration menu closes. Restarting the device is not necessary.



Network IPs are usually managed by a DHCP Server. Therefore the BatFlex IP must not be in the specified range of the DHCP.

Otherwise IP address collisions may occur. Usually there is a static IP range where one should set up the BatFlex system with.



It's advised to avoid bigger networks (for example global company networks) especially in case of very long measurements.

Unexpected or unavoidable maintenance of the network could cause measurement data loss.

The BatFlex Device is designed as amodular System where measurement cards can be replaced whenever the device is turned off. The

onboard microprocessor is able to recognize the new configuration on the next power up.

Card Type

BatFlex FPGA Card

BatFlex Reference Card

BatFlex Small Card

BatFlex Small Dual Card

Astrol Electronic AG reserves the right to change specifications without notice

Bat FLEX Manual

Card Function

This card contains the onboard data processing controller and the network adapter.

This card contains a high precision, thermally regulated voltage reference which is used periodically to

calibrate measurement cards.

This card is a measurement card for small currents up to 24 mA. The full specification can be found in

chapter 2.5.4

This card is a compound consisting of two stacked BatFlex Small cards. This allows to use up to 8

channels with a single card slot. The full specification can be found in chapter 2.5.4.

4/19

AD-10069-007 Rev. 03