Air Hogs Havoc Razor Buku Petunjuk - Halaman 3

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mainan Air Hogs Havoc Razor. Air Hogs Havoc Razor 4 halaman.

Halaman Cetak

2. GROUND CRUISING:

The helicopter will be in car mode by default under the following conditions:

1. The throttle is positioned at minimum.

Ground Cruising:

Put the helicopter on a smooth surface. Slowly increase the throttle. Slowly

push the throttle stick up to make helicopter cruise faster (pic.14). Slowly

push the throttle stick down to make helicopter cruise slower (pic.15).

pic.14

pic.15

3. LIFT-OFF PROCEDURE (after Trimming procedure):

- During Car Mode, gently push the throttle stick up to make the

helicopter cruise.

- When the helicopter is cruising, push the LEFT or RIGHT Transition Button

once to activate the flight mode. Slowly push the throttle stick up to make

helicopter fly.

- DO NOT look at the controller/charger but focus on the helicopter.

- As soon as the helicopter leaves the ground, reduce the throttle slightly.

- Make slow gentle adjustments when reducing or increasing throttle.

4. FLIGHT CONTROL:

To hover up or down:

When the helicopter flies steadily, you can slowly push the throttle stick

up to make helicopter fly higher, or release the stick a bit to make the

helicopter fly lower. Only small amounts of stick position change are

required for smooth flying. (pic.18 & pic.19)

Hover up

pic.18

Hover down

pic.19

Accelerate & Decelerate:

If you turn the helicopter slowly counterclockwise, the helicopter will decelerate. And if you turn it clockwise, it will accelerate.

5. FLYING INDOORS

Location – Fly in a wide-open room [ideally over 10 ft (W) x 16.5 ft (L) x 8 ft (H)], away from breakable items. Avoid flying near vents and/or fans, as these may

overpower the Havoc Razor™ helicopter and make it difficult to control. NOTE: Always get permission to fly your Havoc Razor™ helicopter indoors.

CAUTION: Never fly near your face. Keep rotor away from your fingers, hair, eyes and other body parts. Always lift off from a flat surface. Never hold the flying

heli in your hand when lifting off. DO NOT launch heli near people or animals. Stay away from obstacles and electrical hazards.

FORWARD WEIGHTING

If you would like to adjust the directional

control of your Havoc Razor™

helicopter, you have the option of putting

on the optional CG Adjuster labels. Stick

one label on the bottom of the

helicopter's nose as needed. These will

forward weight the helicopter and allow

for a different flight performance.

HOW TO FIX YOUR TWIN ROTORS

If the linkage between your twin rotors comes undone and is dangling below the bottom rotor,

it is very EASY to fix! (A)

Carefully re-attach the linkage back onto the top connector and gently push it into place. (B)

While your there, you might want to check around the area for any fibers or debris that might

affect your flight performance. Carefully remove it with tweezers and you are ready to start

flying again!

HOW TO ADJUST YOUR HELICOPTER'S FLIGHT PERFORMANCE

2. The helicopter and/or the controller/charger is restarted (switched "OFF" and

then switched back "ON").

Turn counterclockwise and clockwise:

Slowly push the direction stick left to make the helicopter turn

counterclockwise (pic.16). Slowly push the direction stick right to make

helicopter turn clockwise (pic.17).

pic.16

pic.17

- VERY gently add throttle if the helicopter goes down.

- VERY gently reduce throttle if the helicopter goes up.

- For turning, give short and small inputs to the direction stick (most beginners

will easily over control the helicopter).

- For moving forward, turn the helicopter pointing to more open space before

pushing the forward buttons.

NOTE: The helicopter won't hover even if the throttle is positioned at

maximum in Car Mode.

Turn counterclockwise and clockwise:

Hold the helicopter at a height. Push the direction stick toward the left to

turn counterclockwise (pic.20), and push the direction stick toward the

right to turn clockwise. (pic.21)

pic.20

pic.21

Optional

CG Adjuster labels

Stick the CG Adjuster

label here to obtain

different performance.

WRONG

RIGHT