Canon imagePROGRAF W8400 Panduan Pengemudi - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pengemudi untuk Perangkat lunak Canon imagePROGRAF W8400. Canon imagePROGRAF W8400 24 halaman. Hdi driver guide
Juga untuk Canon imagePROGRAF W8400: Brosur & Spesifikasi (8 halaman), Brosur & Spesifikasi (4 halaman), Brosur & Spesifikasi (12 halaman)

Halaman Cetak

Canon imagePROGRAF W8400 Panduan Pengemudi

imagePROGRAF HDI Driver Guide

5. Perform the settings that you need for the print job.

For more details about how to perform the settings in the Plotter

Note

Configuration Editor dialog box, please refer to Chapter 3, "Setting Up a

Print Job" (p.3-1).

6. Click the OK button to close the Plotter Configuration Editor dialog box.

The Plot dialog box opens.

• The content of the settings done in the Plotter Configuration Editor

Note

• For more details about the Plot dialog box, please refer to the AutoCAD

7. Perform the settings that you need on the Plot Settings and Plot Device sheets, then click

the OK button.

The print job begins.

• If the output exceeds the number of pixels prescribed for the media, in

Note

• Some media may not allow printing with certain resolution settings. If you

• A message from AutoCAD is displayed when printing starts. Press the

Printing

dialog box are reflected in the Paper size and paper units settings on

the Plot Settings sheet of the Plot dialog box.

manual.

order to prevent AutoCAD from hanging up during the print job a warning

dialog box opens and asks if you want to lower the resolution or reduce

the number of colors. If this occurs, click the OK button to cancel the

print job and then lower the resolution or reduce the number of colors.

have selected a resolution setting that cannot be used for printing, then a

dialog box will open and prompt you to change the resolution. If this

occurs, click the OK button to cancel the print job and then lower the

resolution.

OK button to execute the print job. This message display can be

disabled with the Options setting in the AutoCAD Tools menu. For more

details, please refer to the AutoCAD manual.

2-2