Daekyung Black Bear DH-100 Panduan Pengguna - Halaman 15
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kerekan Rantai Daekyung Black Bear DH-100. Daekyung Black Bear DH-100 18 halaman. Chain block
Halaman Cetak
7.2.3 Annual Inspection
1) Disassemble the gear box and check for abrasion/damage of gear parts. Replace them if necessary.
2) Check for abrasion/damage of ratchet, stopper (pawl), or brake lining. Replace them if necessary.
3) When the inspection is completed, assemble the hoist and fill the lubricating grease.
4) Check for any unusual noise, etc. by hoisting/descending the hoist about 40-50cm for 2-3 times
without any load suspended. Then try the same inspection again with a load suspended, and check for
any sliding and other problems. Use the hoist if everything is working properly.
7.3 Check List
Part
Body
Load Chain
Top & Bottom Hook
Other
Black Bear is a registered trademark of Daekyung Co., Ltd.
1521-6 Dadae-dong, Saha-gu, Busan, Korea
Check List
Exterior Appearance
Noise
Side Plate
Reduction Gear
Load Sheave
Rust/Dent
Oil Lubrication
Deformation
Holder
Bottom Hook Pin
Safety Latch
Hand Chain
BLACK BEAR HOIST
Check Standard
There should not be any rust, dent, or damage.
There should not be any unusual or excessive noise.
There should not be any dent, abrasion or deformation.
There should not be any dent, abrasion or deformation.
There should not be any dent, abrasion or deformation.
There should not be any rust, dent, or deformation.
Oil must be thoroughly and evenly distributed.
Hooks should not be deformed (sagging or cracked open).
There should not be any dent, abrasion or deformation.
There should not be any abrasion or bending.
Safety Latch must be in place and it should move freely.
Hand chain must operate smoothly.
- 15 -
Tel: +82)51-264-6611 Fax: +82)51-264-6615