Doremi Labs HDVI-20d Panduan Pengguna - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Konverter Media Doremi Labs HDVI-20d. Doremi Labs HDVI-20d 16 halaman.
Halaman Cetak6.6 Output Settings
DVI
-Auto (default): Use with all monitors up to 1920x1200. If the monitor reports a bad
Resolution
or unsupported resolution, the HDVI-20d will default to 1280x1024. In the case
where this same monitor does not support 1280x1024, the output resolution can
be forced using the infrared remote control and without the OSD interface by
using the TV/Video + Number combination (see paragraph 3.1)
-1024x768, 1280x720, 1280x768, 1280x1024, 1366x768, 1400x1050, 1920x1080,
1920x1200 and 1080i
DVI
-48Hz: Forces the DVI output to 48Hz
Frequency
-50Hz: Forces the DVI output to 50Hz
-60Hz: This is the default mode, it should work with all displays 1920x1200 or below
-Frame Sync: Eliminate motion artifacts by forcing the DVI output signal frequency
to the same or double the SDI input frequency.
All 24 and 48 FPS formats will be displayed at 48Hz
All 25 and 50 FPS formats will be displayed at 50Hz
All 29.97 (30) and 59.94 (60) FPS formats will be displayed at 59.94Hz (60Hz)
Pattern
This menu has been removed in version 1.38 and higher. When input is set to pattern,
Mode
the only available pattern is Color Bars.
H Sync
This setting is normally detected from the EDID message. If for any reason the EDID
Width
is wrong, these settings can be manually adjusted. Pressing ENTER twice will restore
the default value
V Sync
Same note as for H Sync Width
Width
H Back
Same note as for H Sync Width
Porch
V Back
Same note as for H Sync Width
Porch
6.7 Miscellaneous Menu
This menu can be used to reset the factory default settings of the unit. It also displays the monitor's
native resolution, the current DVI output resolution, the current DVI output frequency, the infrared
remote control status, the current input and the firmware version. After you reset the factory
defaults, you MUST recycle power on the unit.
The reset function in this menu is different from the Reset I/O settings described earlier.
7 Troubleshooting
If the XDVI-20d does not output video to your monitor, refer to paragraph 6.1 to learn how to
perform a Reset I/O settings.
Try to force the input and output modes using:
• CH+ to force the input to Pattern, SDI, DVI-D, 3: DVI-A
• TV/Video + 0-9 to force the DVI-D output mode (see previous sections for listing)