Asus CUW-AM Manual - Halaman 14

Jelajahi secara online atau unduh pdf Manual untuk Motherboard Asus CUW-AM. Asus CUW-AM 21 halaman.

2. HARDWARE SETUP

9) Primary / Secondary IDE Connectors

(40-1pin PRIMARY/SECONDARY IDE)

These connectors support the provided IDE hard disk ribbon cable.

After connecting the single end to the board, connect the two plugs at the other

end to your hard disk(s). If you install two hard disks, you must configure the

second drive to Slave mode by setting its jumper accordingly. Please refer to

your hard disk documentation for the jumper settings. (Pin 20 is removed to

prevent inserting in the wrong orientation when using ribbon cables with

pin 20 plugged).

TIP: You may configure two hard disks to be both Masters with two ribbon

cables – one for the primary IDE connector and another for the secondary IDE

connector and select the boot disk through the BIOS.

IMPORTANT:

else devices will automatically be limited to UltraDMA/33 mode.

CUW-AM

CUW-AM IDE Connectors

10) Floppy Disk Drive Connector (34-1pin FLOPPY)

This connector supports the provided floppy drive ribbon cable. After connect-

ing the single end to the board, connect the two plugs on the other end to the

floppy drives. (Pin 5 is removed to prevent inserting in the wrong orienta-

tion when using ribbon cables with pin 5 plugged).

CUW-AM

CUW-AM Floppy Disk Drive Connector

UltraDMA/66 IDE devices must use an 80-wire IDE cable or

0 1

NOTE: Orient the red markings on

the floppy ribbon cable to

0 1

CUW-AM User's Manual

PIN 1

NOTE: Orient the red markings

on the IDE ribbon cable to

PIN 1