DORIC DS5011 Panduan Instalasi - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Sistem pembukaan pintu DORIC DS5011. DORIC DS5011 4 halaman. Sliding door keeper
Halaman CetakINSTALLATION GUIDE
1. Placing Keeper
Install the Keeper
base, secured loosely
in the CROSS FIXED
holes using the
mounting screws
provided.
Do not tighten the
screws yet.
4. Additional Fixing
(Optional)
a)
If additional INLINE fixing is to
also be used:
a) Remove the two pop out tabs on
the rear of the cover.
b) Fit the side cover (Step 3).
c) Add additional INLINE fixing
screws through the cover cutouts.
DS5010
I SLIDING DOOR KEEPER
v1.1 - 11/08/2021
2. Vertical Adjustment
Adjust the Keeper base vertically
until the correct position is found
in relation to the door lock.
The keeper base offers adjustment
up to 9mm
Now tighten the mounting screws.
a)
c)
5. Horizontal Adjustments
a) To increase horizontal adjustments,
loosen the top and bottom adjustment
screws to the desired amount (up to
5mm)
b) Loosen the centre adjustment screw
until the faceplate comes into contact
with the top and bottom adjustment
screws
b)
c) To decrease the horizontal adjustment,
tighten the centre adjustment screw, and
then tighten the top and bottom
adjustment screws until firm
Head office:
38 Redfern St
Wetherill Park NSW 2164
Australia
3
3. Fitting Cover
Install the side cover,
Unless adding INLINE
fixing proceed to step 5.
Ph: 1300 132 389
Fax: 1300 652 292
www.doric.com.au