Asus H110M-C/HDMI Manual - Halaman 11

Jelajahi secara online atau unduh pdf Manual untuk Motherboard Asus H110M-C/HDMI. Asus H110M-C/HDMI 27 halaman.
Juga untuk Asus H110M-C/HDMI: Panduan Memulai Cepat (2 halaman)

Halaman Cetak

Clear RTC RAM (2-pin CLRTC)

This header allows you to clear the CMOS RTC RAM data of

the system setup information such as date, time, and system

passwords.

To erase the RTC RAM:

Turn OFF the computer and unplug the power cord.

Use a metal object such as a screwdriver to short the two

pins.

Plug the power cord and turn ON the computer.

Hold down the <Del> key during the boot process and enter

BIOS setup to re-enter data.

If the steps above do not help, remove the onboard battery and short the two pins again

to clear the CMOS RTC RAM data. After clearing the CMOS, reinstall the battery.

Speaker connector (4-pin SPEAKER)

This 4-pin connector is for the chassis-mounted system warning speaker. The

speaker allows you to hear system beeps and warnings.

System panel connector (10-1 pin F_PANEL)

This connector supports several chassis-mounted functions.

Intel

H110 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1~4)

These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA

6.0 Gb/s signal cables.

USB 2.0 connector (10-1 pin USB910)

Connect the USB module cable to any of this connector, then install the module

to a slot opening at the back of the system chassis. This USB connector complies

with USB 2.0 specifications and support up to 480Mbps connection speed.

LPT connector (26-1 pin LPT)

The LPT (Line Printing Terminal) connector supports devices such as a printer.

LPT standardizes as IEEE 1284, which is the parallel port interface on IBM PC-

compatible computers.

Chassis intrusion header (4-1 pin CHASSIS)

This header is for a chassis-mounted intrusion detection sensor or switch Connect

one end of the chassis intrusion sensor or switch cable to this header. The chassis

intrusion sensor or switch sends a high-level signal to this header when a chassis

component is removed or replaced. The signal is then generated as a chassis

intrusion event.

By default, the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper

cap. Remove the jumper caps only when you intend to use the chassis intrusion

detection feature.

ASUS H110M-C/HDMI

CLRTC

PIN 1

1-3