Canon WebView Livescope MV Ver. 2.1 LE Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Perangkat lunak Canon WebView Livescope MV Ver. 2.1 LE. Canon WebView Livescope MV Ver. 2.1 LE 24 halaman. Versatile monitoring software

Halaman Cetak

Installing

Prior to Installation...

Before installing MV LE, be sure that the PC in which it is to be installed and the camera servers satisfy

the conditions described below.

Preparing the PC

Check that the PC where MV LE is to be installed satisfies

the operating environment of MV LE(

the screen resolution to XGA (1024

If your screen resolution is set to XGA, use the "Control on Side" mode for the

camera control panel display (

Note

Installing the Camera Servers

If the VB-C10/VB-C10R or VB150 is being used, there is no need to upgrade the firmware.

However, if the VB101 is being used, check to be sure that the firmware version is 3.0 or later. The

firmware is available for free at the following.

URL:http://www.canon.com/webview/

Check to be sure the camera server has been correctly installed and that the initial settings

(network settings) have been made. Then connect to the network.

Please refer to the manual supplied with the camera server for procedures on how to install and set

the camera server.

The camera server's "Maximum Number of Clients" setting must be set to 4

or more for the VB150 (or VB101). To make settings, use the setting page on

Note

the camera server. While factory default settings meet the above

requirements, the settings must be checked if any changes are made.

P.5). Be sure to set

768) or higher.

P.13).

Display Properties