Canon LV-7325U Panduan Pemilik - Halaman 43
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Proyektor Canon LV-7325U. Canon LV-7325U 48 halaman. Canon multimedia projector owner's manual lv-7325u
Halaman Cetak
When the life of the Lamp of this projector draws to an end, the LAMP REPLACEMENT indicator lights red.
When the image becomes dark or the color of the image becomes unnatural, replacement of the Lamp is
required.
CAUTION
For continued safety, replace with a lamp assembly of the same type.
Allow the projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector
can become very hot.
Do not drop the lamp assembly or touch the glass bulb! The glass can shatter and may cause injury.
Follow these steps to replace the lamp assembly.
1
Turn off the projector and disconnect the AC plug. Allow the
projector to cool for at least 45 minutes.
2
Remove a screw with a screwdriver and remove the Lamp
Cover.
3
Remove 2 screws with a screwdriver and pull out the Lamp
Assembly by grasping the handle.
4
Replace the Lamp Assembly with new one and tighten 2
screws. Make sure that the Lamp Assembly is set properly.
And replace the Lamp Cover and tighten a screw.
Connect the AC Power Cord to the projector and turn the
5
projector on.
Reset the Lamp Replacement Monitor Timer (refer to the
6
section "Lamp Replacement Monitor Timer" below).
NOTE : Do not reset the LAMP REPLACEMENT MONITOR
TIMER, when the lamp is not replaced.
ORDER REPLACEMENT LAMP
Replacement Lamp can be ordered through your dealer. When ordering the Lamp, give the following
information to the dealer.
Model No. of your projector
Replacement Lamp Type No. : LV-LP05
LAMP REPLACEMENT MONITOR TIMER
Be sure to reset the Lamp Replacement Monitor Timer when the Lamp Assembly is replaced. When the
Lamp Replacement Monitor Timer is reset, the LAMP REPLACEMENT indicator stops lighting.
Turn the projector on, and press the MENU button and the ON-SCREEN MENU will appear. Press the POINT
1
LEFT/RIGHT buttons to select SETTING
dialog box SETTING MENU will appear.
2
Press the POINT DOWN button and a red-arrow icon will appear. Move the arrow to Lamp age, and then press the
SELECT button. The message "Lamp replace monitor Reset?" is displayed.
3
Select [Yes] to reset the Timer.
Do not reset the Lamp Replacement Monitor Timer, except after the lamp is replaced.
LAMP REPLACEMENT INDICATOR
LAMP REPLACEMENT
: LV-7325U
(Service Parts No. 610 280 6939)
and press the SELECT button (refer to the page 40). Another
LAMP COVER
HANDLE
LAMP
ASSEMBLY
APPENDIX
43