Bollhoff 4080 Tool Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Bor Bollhoff 4080 Tool. Bollhoff 4080 Tool 9 halaman.

Halaman Cetak

Connection to compressed air system

All tools are air-driven, at an optimum pressure of 6 bar. We recommend the use of air treatment

units including lubrication, ltering and pressure control on the compressed air supply system.

These devices must be installed at maximum 3 metres from the tool in order to ensure optimum

tool service life and minimum maintenance.

All air hoses MUST MANDATORILY FEATURE AN INNER DIAMETER OF AT LEAST 6.4 mm

Operating method

The tool can be operated in all positions, either carried in hand or suspended.

Operating procedure

- Connect the air supply to the tool.

- O er up the RIVKLE

and automatically initiate RIVKLE

(Push-Pull system).

- Introduce the RIVKLE

- Press the trigger and keep depressed until the device is fully released.

This action both crimps the RIVKLE

and releases it from the mandrel (by unscrewing).

CAUTION: THE TRIGGER MUST BE KEPT DEPRESSED FOR THE ENTIRE CYCLE. RELEASING THE

TRIGGER WOULD RESULT IN FAULTY CRIMPING.

Crimping pressure adjustment

CAUTION: WHEN DELIVERED, THE TOOL IS DELIBERATELY SET TO 0 MM STROKE. THEREFORE, IT

IS MANDATORY TO ADJUST THE DEVICE WHEN PUTTING INTO SERVICE.

EXCESSIVE STROKE CAN DAMAGE RIVKLE

PREVENT MANDREL UNSCREWING.

WHEN CORRECT CRIMPING IS OBTAINED, RECORD THE POSITION OF THE INDEX MARK ON THE

ADJUSTMENT RING, FOR REFERENCE.

Unscrewing button

In case of unscrewing problem, the 4080 tool is

equipped with an unscrewing control button on

top of the crimping trigger. To start unscrewing,

press unscrewing button (1), then press crimping

trigger 2 at the same time.

[email protected]

Visa, Mastercard, Discover & AMEX Accepted

onto the mandrel. A slight pressure will start the motor

screwing in onto the nose-piece, then motor shutdown

into the hole in intended application.

into the intended application

- Check that air system pressure is set between 5,5 and 7 bar.

- Before crimping, adjust stroke to 0 by turning the adjustment ring

to minimum position in (-) direction.

- Gradually increase crimping stroke by turning the adjustment ring

towards (+). This adjustment ring features

3 index marks. 1/3 turn corresponds to 0.5 mm

(1 complete turn = 1.5 mm).

- At each step, test RIVKLE

until obtaining optimum crimping.

- Optimum crimping (dimension s) is indicated

in your RIVKLE

catalogue

TAPPED THREADS, AS WELL AS THE MANDREL, OR

ISO CERTIFIED

Fax: 262.252.5033

crimping quality,

CALL TODAY

800.236.3200