Cantaloupe Radio MDeck BA-2 Panduan Pemilik - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Stereo Mobil Cantaloupe Radio MDeck BA-2. Cantaloupe Radio MDeck BA-2 8 halaman. Bluetooth retrofit kit, compatible with cm5905/cm5907/cm5908

Halaman Cetak

OPERATION

The remainder of this manual describes the operation of

your MDeck BA-2. The BA-2 works similarly in all 3 radios it

supports, but with some slight differences. Therefore, we'll

first cover common functionality, then cover model-specific

controls on the following pages.

AUDIO SOURCES

With the MDeck installed, your radio has 3 possible audio

sources: tuner (AM, FM, etc.), Bluetooth, and a 3.5mm aux-

iliary input. Cycling through these sources will be covered

later. As a shorthand, the selected source may be referred

to as the "mode" throughout this manual (ex. "Bluetooth

mode" means Bluetooth source is selected).

The current source can be seen from the radio's LCD dis-

play. In Bluetooth mode, the MTL indicator will be either

blinking or solid. In aux mode, the indicator will be off, and

in tuner mode, the display will show the current station as

normal.

BLUETOOTH CONNECTIONS

The MDeck doesn't have any special "pairing" mode to en-

ter to connect a new device. Instead, it is always ready to

connect a new device whenever it's not already connected.

This state is indicated by MTL blinking while in Bluetooth

mode. To connect, open your device's Bluetooth settings

and connect to "MDeck BA-2". After connecting, MTL will

remain on.

In Bluetooth mode, a long press on the volume knob trig-

gers one of two actions: if a device is connected, it causes

a disconnection from that device; if nothing is connected,

the MDeck attempts to reconnect the last device. Note this

happens automatically when the radio is powered on.

INSTALLATION FAULT DETECTION

To protect against damage due to improper installation,

the BA-2 safely detects the radio in which it is installed at

each power-on. If one of the supported radios cannot be

detected, a descending four-note chime will play shortly af-

ter startup to indicate this condition and functionality will be

significantly reduced. This condition is caused by improper

installation of the white flexible cable into the BA-2 board.

Ensure the cable is inserted completely and, in the case of

the CM5905 or CM5907 radio, aligned properly within the

connector.