Bolton Tools BS-128HDR Panduan Pengoperasian - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Melihat Bolton Tools BS-128HDR. Bolton Tools BS-128HDR 16 halaman. Horizontal and vertical metal cutting band saw
Halaman Cetakdepression in the belt when applying pressure with your thumb.
12. Tighten the head screw holding the motor mounting plate to the guard
plate.
13. Connect the electrical harness to the motor terminal box. The motor
should be protected with a time delay fuse or circuit breaker with a
rated amperage slightly greater than the full-load amperage of the
motor.
WORK SET UP
1. Raise the saw head to vertical position.
2. Open vise to accept the piece to be cut by rotating the wheel at the end
of the base.
3. Place workpiece on saw bed. If the piece is long support the end.
4. Clamp workpiece securely in vise
WORK STOP ADJUSTMENT
1. Loose the thumb holding the work stop casting to the shaft.
2. Adjust the work stop casting to the desired length position.
3. Rotate the work stop to as close to the bottom of the cut as possible.
4. Tighten thumb screw.
5. Do not allow the blade to rest on the work while the motor is shut off.
BLADE SPEEDS
When using your band saw always change the blade speed to best suit
the material being cut. The material cutting shaft givers suggested settings
for several materials.
4 SPEED MATERIAL CUTTING CHART
Material
Tool, Stainless alloy
Steels, bearing bronze
OPERATION
Speed MPM
60Hz
50Hz
24
19
Belt Groove Used
Motor pulley
Saw pulley
Small
Large