Daewoo electricals HEA1187 Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk Pemanas Daewoo electricals HEA1187. Daewoo electricals HEA1187 8 halaman. Mini convector heater

Electrical Connections

This appliance is fitted with a fused three-pin plug to BS 1363. If the plug has

to be removed, it should be cut off and carefully disposed of immediately. To

avoid a possible shock hazard, do not insert the discarded plug into a mains

socket.

Fitting a new plug

The mains lead must be connected as shown below. The wires are coloured

with the following code - Brown wire = Live (L), Blue wire = Neutral (N),

Green & Yellow = Earth (E).

 The Blue wire must be connected to the terminal marked N or coloured Black.

 The Brown wire must be connected to the terminal marked L or coloured Red.

 The Green and Yellow wire must be connected to the terminal marked E or

coloured Green.

 Check that there are no cut or stray strands of wire inside the plug.

 Use a 13 Amp BS 1362 fuse, only use BSI or ASTA approved fuses.

 If you are in any way unsure which plug or fuse to use, always refer to a

qualified electrician.

 After replacing or changing a fuse on a moulded plug, the cover must be refitted

to the plug; the appliance must not be used without a fuse cover.

WARNING: Do not wrap the cord around the heater for storage.

Connect

Green &

Yellow to

Earth (E

)

Connect

Blue to

Neutral (N)

Connect

Brown to

Live (L)

Ensure the outer sheath of the mains

lead is securely held by the cable clamp