Daewoo electricals SDA1132 Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk Penggorengan Daewoo electricals SDA1132. Daewoo electricals SDA1132 10 halaman. Digital air fryer

forwards and then press the Basket Release Button (3), lift the basket clear

of the drawer using the Handle (4).

Care must be taken when pulling the fryer drawer out during the cooking

process.

The red light at the centre of the Cooking Indicator (17) will go on and off

during cooking showing the set temperature is being maintained (the

rotating blue LED 'blades' on the display show that the internal fan is

operating). This is quite normal.

Do not fill the Air Fryer with oil.

Cooking Tips

• A large amount of ingredients require a longer cooking time, a smaller

amount of ingredients requires a slightly shorter cooking time.

• Shaking the ingredients halfway through the cooking gives a better end

result and helps ingredients being unevenly fried.

• Add a little oil (approximately 1/2 Tablespoon) to newly peeled potatoes for

a crispier result. Fry within a few minutes once the oil has been added.

• For crispier chips do not fill the basket to maximum.

Cleaning and Maintenance.

• Always unplug the Air Fryer from the mains supply and allow to fully cool

before cleaning.

• Do not clean any part of the air fryer in a dishwasher.

• Do not submerge any part of the main body, mains cable or plug in water

or any other liquids.

• Wipe excess oil from the basket and drawer with kitchen roll or similar.

• Wipe clean the main body of the Air Fryer with a damp cloth.

• The basket and drawer can be washed in warm soapy water.(rinse and dry

thoroughly before using again)

• Never clean any part of the Air Fryer with harsh or abrasive cleaners.

This appliance is fitted with a fused three-pin plug to BS 1363. If the plug

has to be removed, it should be cut off and carefully disposed of

immediately. To avoid a possible shock hazard, do not insert the discarded

plug into a mains socket.

Fitting a new plug

The mains lead must be connected as shown below. The wires are

coloured with the following code - Brown wire = Live (L), Blue wire =