Dot-Spot colorgarden 1er Set Panduan Operator - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Operator untuk Pencahayaan Lanskap Dot-Spot colorgarden 1er Set. Dot-Spot colorgarden 1er Set 11 halaman. Mini led garden spot

Halaman Cetak

Assembly

1. Assembly with steel peg

The stainless steel spike which is fixed to the housing is suitable for mounting on

loose surfaces e.g. earth, sand and others. Attach the mounting bracket on the

spike first. Use therefore the screw which is included with the spike. Check the

firmness of the ground and push the spike into the ground. If necessary, put a

piece of wood an it and tap it lightly with a hammer. If necessary the spot has to

be removed from the assembly bracket.

2. Assembly with mounting bracket (enclosed)

Please remove first the steel peg and the spot from the assembly bracket, by

declamping the screws. Mark the position of the hole for the assembly bracket on

the surface. Drill a hole in the ground and equip it with a suitable plug. The inclu-

ded plug is suitable for mounting on substrates made of concrete, stone and

masonry. For wood surfaces, the mounting angle can be mounted directly with an

appropriate screw with using the plug. In the case of hardwood it may be useful

drilling a hole before mounting. Place the mounting bracket right over the plug,

align in the desired direction and tighten it up with an appropriate screw. Now the

Mini LED garden spot can be attached to the mounting bracket. Plug an appropri-

ate screw through the hole of the mounting bracket and fix it laterally with a hexa-

gon-wrench into the threaded hole on the light housing. Adjust the spotlight before

tightening into the desired direction.

3. Using the extension adapter and installation extensions (optional)

Instead of the mounting bracket you can also use the extension adapter and

installation extensions to fix the Mini LED garden spot. This is especially recom-

mended if you want to mount the spot in an elevated position. The extension

adapter may be implemented using appropriate wall plugs with M6 internal thread

to be mounted on various substrates.

Plug connection / connection of the spot

Plug connection

Connection with 12 V low-voltage plug system

Mini LED spot 12 V / 3 W

power supply

12 V

5 m

Mini LED spot 12 V / 3 W

5 m

Connection of the Mini LED garden spot (single set)

Place the Mini LED garden spot on the appropiate area.

Lay the power line in direction of the socket-outlet, the consistable special cable

can be directly layed in the ground.

Connect cable of spot with power supply and save connection with union nut.

Put safety plug into power socket - Ready.

230 V 50 Hz

3-way

cable

5 m

distributor

power supply

5 m

12 V

230 V 50 Hz