Dot-Spot aq EH 50 Panduan Operator - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Operator untuk Pencahayaan Kolam Renang Dot-Spot aq EH 50. Dot-Spot aq EH 50 16 halaman.

Mechanical installation

in foil pools or other thin-walled pools

for the aq 5

■ big hole d=40 mm for the spot,

■ 2 holes d=3.5 for the fixing screws of the spot, as well as

■ 6 holes d=3.5 for the flanging screws

for the aq 20

■ big hole d=72 mm for the spot,

■ 3 holes d=4.5 for the fixing screws of the spot, as well as

■ 6 holes d=3.5 for the flanging screws

The sequence of components during flanging seen from the exterior surface of the pool towards

the inside:

■ Installation sleeve

■ Gasket

■ Pool wall (foil or thin pool wall)

■ Sealing flange (the countersink for the screws must face away from the pool wall.)

Absolutely adhere to the described sequence. Ensure that the holes for the fixing screws in all parts

lie on top of each other. Maybe it is necessary to turn a component in order to achieve that.

Clean the sealing surfaces, they must be dust-free and dry. Mount the sealing flange to the instal-

lation sleeve using the six enclosed Torx countersunk screws M3 x 12 and press the sealing gasket

against the installation sleeve. Carefully tighten the screws crosswise consequently sealing the

connection between the pool and the installation sleeve.

Tightening torque of the M3 flanging screws: max. 2 Nm.

Equipotential bonding

According to the local circumstances, observe the applicable requirements for the equipotential

bond at the swimming pool. In case an equipotential bond is needed, use the crimping eyelet

screwed to the installation sleeve for attaching it.

Install the spot as described in the installation instruction of the spot.

■ The installation sleeve and the sealing flange are maintenance-free.

■ The installation sleeves are made of stainless V4A steel. However, depending on the environ-

mental conditions and the surfacing material, the metal parts may present the so-called flash

rust, but this does not constitute a defect.

■ The sealing flanges are made of stainless V4A steel. However, depending on the environmental

conditions and the surfacing material, the metal parts may present the so-called flash rust, but

this does not constitute a defect. After installation, only the rim is slightly visible. Flash rust can