DAGE-MTI DC-200 Panduan Pengguna - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kamera Keamanan DAGE-MTI DC-200. DAGE-MTI DC-200 17 halaman. Color

Focus Adjustment (mechanical back-focus)

The Back-Focus is calibrated at the factory and should not

need readjustment, however if adjustment is necessary follow

the procedure below:

1. Loosen the set screws on the top and bottom of front

casting with a 1.5mm hex wrench.

2. Set the lens to maximum aperture and to ∞ focus

position.

3. View an object which is 20M or more away, then adjust

lens mount ring until the image is in focus.

4. Tighten the set screws.

Connector pin-outs

OSD Keyboard Connector

Y/C Video Connector

This 8 pin connector is used for the OSD

Remote to set-up or change camera function

settings. The pin-out is as follows:

1. RIGHT

2. LEFT

3. UP

4. DOWN

This 4 pin connector provides Y (luminance)

and C (color) output signals to be terminated

into 75Ω. The pin-out is as follows:

1. GROUND

2. GROUND

5. MENU

6. ONE PUSH(AWB)

7. GROUND

8. N/C

3. Y (LUMINANCE)

4. C (COLOR)