DAGON SPM-12 Instruksi Manual - Halaman 4

Jelajahi secara online atau unduh pdf Instruksi Manual untuk Pengontrol DAGON SPM-12. DAGON SPM-12 8 halaman. Dmx-512 controller – 12 out dc / pwm

DAGON Lighting

2. SPM-12 controller configuration.

The SPM-12 controller is a device freely programmable by the user. Configuration

consists of entering the driver control 3 digit code (000 to 999), which determine the

operation of the controller. To enter the codes 2 buttons have to be used marked as CODE and

PLUS and also 2 signalization diodes – green and yellow, as shown in the Figure 1.

The meaning off all steering codes is mention in table 1 on page 6 of this manual.

Typically, correct and complete configuration of the driver SPM-12 requires to type a few

control codes. This is the correct action from the user part.

To enter the code to the driver SPM-12 button CODE need to be pressed. The green diode

will light off and the yellow one will light on.

Entering the first digit of code:

Button PLUS need to be press as many times as the first digit of code is from 0 to 9.

Every press is signalize by a short blinking of green diode.

After set in the first digit, button CODE need to be press one more time.

The yellow diode will blink (light off for half a second and light on again)

which is the signal to enter the second digit of code.

Entering the second digit of code:

Button PLUS need to be press as many times as the second digit of code is from 0 to 9.

Every press is signalize by a short blinking of green diode.

After set in the second digit button CODE need to be press one more time.

The yellow diode will blink and it is the signal to set in the third digit.

Entering the third digit of code:

Button PLUS need to be press as many times as the third digit of code is from 0 to 9.

Every press is signalize by a short blinking of green diode.

After set in the third digit button CODE need to be press one more time.

The yellow diode will light off and the green one light on – this is the signal

that the code is ready.

After entering the code SPM-12 controller passes for regular operation, and to control the

outputs Q1-Q12 in the manner which is set out the current configuration – by control codes.

In order to enter another code, proceed similarly as described above. The same code can

be entered multiple times, which has no negative influence to the operation of the controller.

Not all the codes (available from range 000-999) are used. When set in the codes which

has no function it will not change the work of controller. This kind of code is signalized as the

incorrect code by a triple blinking of yellow diode just after set-in all three digits of code.

Ale set-in codes are remembered in EEPROM memory of SPM-12 controller. Lack of

power doesn't cause losing the settings made by CODE and PLUS buttons.

If any time, while configuration, the buttons CODE and PLUS will be not pressed by 1

minute, SPM-12 automatically stop configuration and goes to the regular work.

SPM-12 – controller DMX-512 – 12 OUT DC / PWM