Dotronix M SERIES Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kontrol Jarak Jauh Dotronix M SERIES. Dotronix M SERIES 12 halaman. Handheld addressable remote controls

Halaman Cetak
INDEX
ACTIVATING OPTIONS
ADVANCED SETUP MENU
AVAILABLE MENUS
COLOR MENU
CUSTOM OPTIONS
DE-ACTIVATING SECURITY
GEOMETRY MENU
GETTING STARTED
INTRODUCTION
IR MODULE 20
IR MODULE 29
JUMPER LOCATIONS
LOST OR FORGOTTEN SECURITY CODE
MENU - ADVANCED SETUP
MENU - AVAILABLE
MENU - COLOR
MENU - GEOMETRY
MENU - SELECTION
MENU - TO ACTIVATE
ON/OFF TIMER PROGRAMMING
PRECAUTIONS
PURITY GUARD TIMER PROGRAMMING
REMOTE CONTROL PICTORIAL
SECURITY DE-ACTIVATING
SECURITY CODE - CHANGING
SECURITY CODE - LOST
SELECTION MENU
SERVICE PACK CONTENTS
SETTING THE CLOCK
TO ACTIVATE MENUS AND CONTROLS
UTILITY INFORMATION SCREEN
WARRANTY
21
INTRODUCTION
Congratulations on your purchase of a new DOT-X Series with HARC
11
(Handheld Addressable Remote Control) option.
7
16
This manual has been prepared to act as a guide in the operation of your unit
6
when the HarcPlus option is installed. Please read the following operating
8
6
instructions carefully before using your unit so that you are familiar with all
11
of its features and capabilities. All precautions and safety warnings should
9
be read and strictly observed.
6
2
SERVICE PACK CONTENTS
2
18
The service pack consists of the following:
17
10
15
7
6
6
6
7
4
13
1
13
GETTING STARTED
12
12
5
Refer to the monitor manual for connecting power and signal to the
19
monitor.
9
8
For initial operation of multiple unit installations, apply power to only one
15
unit at a time, while changing the unit identification number (Unit ID) from
7
the factory set 01 to a sequence of unique numbers for each unit. (See
2
Changing Security Code and Unit Number.)
11
3
Unpack the remote control and install batteries.
15
20
The DOT-X SERIES with HARC responds to remote control inputs in a
manner similar to many other remote control devices including TVs,
VCRS etc. with two important differences. First, a security code is
required before access to any menus is allowed. Second, a unit selec-
tion number is required to select one unit from a group of several units,
allowing individual adjustments to individual units with one remote
control.
Until the security code and unit selection numbers are entered, the
monitor will not respond to the remote control.
•
Storage box
•
Remote Control
•
2 AAA Batteries
•
Adjustment Stick
•
This Manual
2