Doug Fleenor Design PRESET 10 PORTABLE Panduan Pemilik - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Peralatan Perekaman Doug Fleenor Design PRESET 10 PORTABLE. Doug Fleenor Design PRESET 10 PORTABLE 11 halaman.
Juga untuk Doug Fleenor Design PRESET 10 PORTABLE: Panduan Pemilik (6 halaman)
Halaman Cetak
MAIN: Used when multiple stations are in one system. A main station transmits the
sACN data, holds stored looks and exchanges configuration packets with remote
stations. Only the main station may record presets, and set times.
REMOTE: When more than one station is on a universe, one must be set as a main,
and all others set as remote stations with the same universe number. The remote
stations exchange polling information with the main station, allowing button presses at
multiple entrances to track through the whole system.
BUTTONS
RADIO: Button presses fade between presets, one preset is active at a time.
POPO: Piles on presets allowing more than one on at a time. In this pile-on mode, the
PRE10ETHER-A operates in a Highest Takes Precedence (HTP) fashion, outputting the
highest value per slot of the active presets.
DATA
Displays the value of the first slot of the first universe being received by the
PRE10ETHER-A. The Data page does not display data transmitted by the
PRE10ETHER-A. This is provided as a system diagnostic and troubleshooting aide.
JUMPER SETTINGS
The remaining configuration options are not accessed using the LCD and encoder
wheel. Instead these options are accessed by removing or applying a jumper.
JP4 - Rear Lockout – Removal of the JP4 Jumper locks out the rear encoder input and
display output. The LCD image and backlight turn off. Reapplication of the JP4 Jumper
re-enables the LCD and encoder.
JP5 - Force Defaults – All configuration options accessed through the LCD and encoder
are set to default by the following process:
1. Power Down PRE10ETHER-A
2. Remove JP5
3. Power up PRE10ETHER-A
4. Wait 5 seconds
5. Replace JP5
For a listing of each default setting, see the table below.
DHCP
IPv4
Subnet Mask
Universe
Priority
Option
Default Setting
True
10.10.10.10
255.0.0.0
1
100
Page 6 of 10