Doug Fleenor Design DMX512 Panduan Pemilik - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Konverter Media Doug Fleenor Design DMX512. Doug Fleenor Design DMX512 6 halaman. Dmx512 to 0-10 volt analog converter
Halaman CetakThe DMX512 to Analog Converter is an interface device which allows a DMX512 control
console to control 0 - 10 volt analog dimmers or other 0 - 10 volt devices.
The input to the converter is electrically isolated from the outputs. This prevents ground
loops in the dimming control system as well as protecting the console from damage in
the event of dimmer failure. In addition the input is protected against mis-wiring and will
accept up to 120 volts on its DMX512 input without damage to the converter. The
outputs are protected against positive voltages coming up the control cable. Damage to
the converter may occur if high negative voltages are placed on its outputs.
The input accepts DMX512 as specified by the Untied States Institute of Theater
Technology (USITT). The outputs meet the proposed ADC-10 specification.
Input data rate:
Input circuit:
Input signal:
Output circuit:
Output signal:
Output linearity:
Maximum output current: 24 output: 15 mA per channel, 120 mA total all channels
Input/output isolation:
Throughput delay:
output)
Power input:
Dimensions & weight:
PRODUCT DESCRIPTION
SPECIFICATIONS
250 Kilobaud
EIA-485 receiver with series 100 ohm self resetting "fuses"
clamped to +/- 7 volts by Transorb diodes
0.5 volts minimum, 120 volts maximum
LM324 op-amp with 1N4004 series diode
0 to 10.1 volts into 2000 ohm load
5% input to output, 1/2% between outputs
96 output: 15 mA per channel, 360 mA total all channels
greater than 500 volts
less than 0.004 seconds (DMX input change to analog
100 - 120 volts 50/60 hertz, 12 watts (208 - 240 volt optional)
24 output: 9.0" deep, 1.6" high, 5.6" wide, 2.5 pounds
96 output: 8.0" deep, 1.7" high, 16.7" wide, 4.5 pounds
(19" rack adapters are available)
1