Dahua F Series Panduan Memulai Cepat - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Kamera Keamanan Dahua F Series. Dahua F Series 13 halaman. Hd ir bullet network camera
Juga untuk Dahua F Series: Panduan Memulai Cepat (17 halaman), Panduan Memulai Cepat (18 halaman), Panduan Memulai Cepat (17 halaman), Panduan Memulai Cepat (15 halaman), Panduan Memulai Cepat (6 halaman), Panduan Memulai Cepat (16 halaman), Panduan Memulai Cepat (18 halaman), Panduan Memulai Cepat (7 halaman), Panduan Memulai Cepat (17 halaman), Panduan Memulai Cepat (16 halaman), Panduan Memulai Cepat (18 halaman), Panduan Memulai Cepat (12 halaman), Panduan Memulai Cepat (16 halaman), Panduan Memulai Cepat (12 halaman), Panduan Memulai Cepat (18 halaman), Panduan Memulai Cepat (15 halaman)

Dahua Dome Wi-Fi Camera Quick Start Guide

4 Device Installation

Note

Please make sure the installation surface can min support the 3X weight of the camera

and the bracket.

Step 1 Use inner hex wrench in the accessories bag to open dome enclosure by

unfastening locking screws on enclosure.

Step 2 Please take out the installation position map in the accessories bag, and then

paste it on the ceiling or the wall according to your monitor area requirements.

Step 3 Find cross signs on the map, and dig three expansion bolts holes on the

installation surface and then insert three expansion bolts in the holes. Secure

these three bolts firmly.

Note

If user pulls out cable from top of installation surface, you must dig an exit hole on



installation surface according to the installation position map.

If user pulls out cable from side of cable channel, it must go through the U-shape



channel on dome pedestal, and take out cable from the side exit hole on pedestal.

Step 4 Adjust the device installation pedestal to the proper position and then pull cable

through the exit hole on Installation surface. Make direction of TOP sign same

as it on installation position map. Line up the three screw holes in the device

pedestal to the three plastic expansion bolt holes in the installation position. Put

Figure 4-1