Asus AAM6020BI-T4 Panduan Pengguna - Halaman 19

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Router Jaringan Asus AAM6020BI-T4. Asus AAM6020BI-T4 38 halaman. Cpe (customer premises equipment) adsl 4 port router

Halaman Cetak

name; the name must not have spaces and cannot begin with numbers. In this case the unique name is

called STATIC1. Select the encapsulation type (LLC or VC); if you are not sure just use the default mode.

Select the VPI and VCI settings; your DSL service provider or your ISP will supply these; in this case the

DSL service provider is using 0,35. Also select the quality of service (QOS); leave the default value if you

are unsure or the ISP did not provide this information. You can also enable Network Address Translation

(NAT) and the Firewall options. If you are unsure, leave these in the default mode.

Based upon the information your DSL/ISP provided, enter your assigned IP address, Subnet Mask, Default

CPE (if provided), and Domain Name Services (DNS) values (if provided). For the static configuration,

you can also select a bridge connection or a routed connection. Since static IP address is typically used to

host WEB servers, you may want to use a bridge connection.

To complete the connection you must now click the apply button. The apply button will temporarily save

this connection. To make the change permanent you need to click on Tools (at the top of the page) and

select System Commands. At the system commands page, click on Save All.

4.4.2

Modify an Existing Connection

To modify an existing connection, from the Home screen, click setup and then click the connection you

want to modify. The connections are listed as Connection 1 through Connection 8

As a note, if you delete the connection, to make the change permanent you need to click on Tools (at the

top of the page) and select System Commands. At the system commands page, click on Save All.

4.4.3

Modem setup

To configure the DSL modulation type, go to the Home screen, Click setup. Under WAN Setup, select

Modem Setup. This will bring up the modem setup screen. Leave the default value if you are unsure or the

DSL/ISP did not provide this information. For most all cases, this screen should not be modified.

The apply button will temporarily save this connection. To make the change permanent you need to click

on Tools (at the top of the page) and select System Commands. At the system commands page, click on

Save All.

Figure 8 (Static IP Connection Setup)

AAM6030BI User Manual