COM-power corporation LI-1100C Buku Petunjuk - Halaman 13
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Perangkat Keras Jaringan COM-power corporation LI-1100C. COM-power corporation LI-1100C 17 halaman. Line impedance stabilization network 150 khz to 30 mhz
Halaman Cetak5.3.6 Fuse
5.3.7 Fan switch
1 9 1 2 1 E l T o r o R d ● S i l v e r a d o , C a l i f o r n i a 9 2 6 7 6 ● ( 9 4 9 ) 4 5 9 - 9 6 0 0 ● c o m - p o w e r . c o m
The fuse is for the Fan over current protection, it is a 20 x 5mm 1A, 250V (T)
fuse. For continued protection against risk of fire, replace only with fuse of
the specified type, current and voltage ratings
This switch controls the Fan operation. Always turn the fan ON before
powering the EUT via LISN.
CAUTION
The LI-1100 LISNs uses forced air system to keep the air core inductors cool
during the test. Always use the supplied DC adapter to power the internal
fan during the test. Do not obstruct the airflow vents. Use the LISNs in a
ventilated area. Failure to observe these precautions may damage the
LISN. Overheated LISN may also provide incorrect measurement data. In
addition the heat may start a fire or injure test personnel. If the fan stops
working discontinue using the LISN and contact Com-Power for further
assistance.
LI-1100C LINE IMPEDANCE STABILIZATION NETWORK
Page 13 of 17
INSTRUCTION MANUAL
REV022717