Doughpro DP1300 Panduan Perakitan - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Perakitan untuk Alat Listrik Doughpro DP1300. Doughpro DP1300 3 halaman. Rebuilding piston assembly air driven automatic dough press
Halaman Cetak10) INSTALL NEW SET OF O-RINGS
AND LUBRICATE WITH GREASE
PROVIDED.
11) LUBRICATE THE ENTIRE PISTON
AND CYLINDER WITH THE
PROVIDED GREASE
12) RE INSTALL PISTON PLATE
IMPORTANT: MAKE SURE GUIDE
POST GOES INTO BUSHING ON
PISTON.
ILS 2.2
15) RE-CONNECT AIR SUPPLY.
16) USE SOAP & WATER TO
CHECK FOR LEAKS.
17) RE-ATTACH COVER PLATE.
AFTER FOLLOWING ALL STEPS AND PISTON
STILL WONT COME OUT:
THE MACHINE NEEDS TO BE IN NORMAL
POSITION. THEN CONNECT THE AIR HOSE
DIRECTLY TO THE 3/8" FITTING
20281 Harvill Ave, Perris, CA 92570 Toll Free: (800) 624-6717 Fax: (951) 657-4594 REBUILDING PISTON ASSEMBLY DP1300
ILS 2.1
13) REPLACE THE LONG SOCKET HEAD
SCREW. MAKE SURE IT IS TIGHT, BUT
DO NOT OVER TIGHTEN.THE HEX
BOLT WILL BREAK.
14) INSTALL PISTON'S COVER AND THE
12 SOCKET HEAD SCREWS.
20281 Harvill Ave
Perris, CA 92570
Toll Free: (800) 624-6717
Fax: (951) 657-4594
ILS 2.3