Baumer AMG 11 D29 Manual - Halaman 5

Jelajahi secara online atau unduh pdf Manual untuk Konverter Media Baumer AMG 11 D29. Baumer AMG 11 D29 15 halaman. Absolute encoder with devicenet

Halaman Cetak

Safety and operating instructions

Supplementary information

 This manual is intended as a supplement to already existing documentation (catalogues, data sheets and

assembly instructions).

 The manual must be read without fail before initial commissioning of the equipment.

Intended purpose of the equipment

 The encoder is a precision measurement device. It is used to determine angular positions and revolutions,

and to prepare and supply measured values in the form of electrical output signals for the follow-on device

systems. The encoder may only be used for this purpose.

Commissioning

 The encoder may only be installed and assembled by suitably qualified experts.

 Observe the operating instructions of the machine manufacturer.

Safety remarks

 Prior to commissioning the equipment, check all electrical connections.

 If installation, electrical connection or any other work performed at the encoder or at the equipment is not

correctly executed, this can result in a malfunction or failure of the encoder.

 Steps must be taken to exclude any risk of personal injury, damage to the plant or to the operating

equipment as a result of encoder failure or malfunction by providing suitable safety precautions.

 Encoders must not be operated outside the specified limited values (see detailed product documentation).

Failure to comply with the safety remarks can result in malfunctions, personal injury or damage to property.

Transport and storage

 Only ever transport or store encoders in their original packaging.

 Never drop encoders or expose them to major vibrations.

Assembly

 Avoid impacts or shocks on the housing and shaft.

 Avoid any twist or torsion on the housing.

 Do not open the encoder or make any mechanical changes to it.

The shaft, ball bearings, glass pane or electronic components can be damaged. In this case, safe and reliable

operation cannot be guaranteed.

Electrical commissioning

 Do not make any electrical changes at the encoder.

 Do not carry out any wiring work when the encoder is live.

 Never plug or unplug the electrical connection when the encoder is live.

 Ensure that the entire plant is installed in line with EMC requirements. The installation environment and

wiring affect the electromagnetic compatibility of the encoder. Install the encoder and supply cables

separately or at a long distance from cables with high interference emissions (frequency converters,

contactors etc.)

 Where working with consumers which have high interference emissions, make available a separate power

supply for the encoder.

 Connect the encoder to the protective earth (PE) conductor

 Use shielded cable. Ideally, aim a single side connection to protective earth (PE) at the plc side.

 The braided screen, the shield film and the drain wire of the cable must not touch the housing.

Failure to observe these instructions can result in malfunctions, material damage or personal injury.

Disposal

 Dispose of encoder components in accordance with locally applicable legislation.

BUDE_Manual_DeviceNet_EN.doc

22.10.2010/bja

5/15

Baumer Hübner GmbH

Berlin, Germany