Baumer BMSH Manual - Halaman 5

Jelajahi secara online atau unduh pdf Manual untuk Konverter Media Baumer BMSH. Baumer BMSH 19 halaman. Absolute encoder with powerlink interface

Halaman Cetak

2 Safety precautions and operating instructions

2.1 Supplementary information

The present manual is intended as a supplement to already existing documentation (catalogues, data

sheets and mounting instructions).

The manual must be studied carefully prior to initial commissioning of the equipment.

2.2 Intended purpose of the equipment

The encoder is a precision sensing device. It is utilized to determine angular positions and revolutions,

and to prepare and supply measured values in the form of electrical output signals for the downstream

device. Encoders must not be used for any other purpose.

2.3 Commissioning

The encoder must be initialised and mounted only by a qualified expert.

Observe the operating instructions of the machine manufacturer.

2.4 Safety instructions

Check all electrical connections prior to commissioning of the equipment.

If mounting, electrical connections or any other work performed at the encoder and the equipment is not

correctly executed this can result in malfunction or failure of the encoder.

Corresponding safety precautions must be provided and observed to exclude any risk of personal injury,

damage to material or operating equipment as a result of encoder failure or malfunction.

The encoder must not be operated beyond the limits (see supplementary documentation).

Failure to observe these safety instructions can result in malfunctions, material damage or personal injury.

2.5 Transport and storing

Only ever transport or store the encoder in its original packaging.

Never drop the encoder nor expose it to major shocks.

2.6 Mounting

Avoid impacts or shocks on housing and shaft/end shaft.

Avoid any twist or torsion on the housing.

Never provide rigid connections between encoder shaft and drive shaft.

Do not open the encoder or carry out any mechanical modifications.

Shaft, ball bearings, glass disc or electronic components can be damaged thereby and a safe and reliable

operation is no longer ensured.

2.7 Electrical commissioning

Do not carry out any electrical modifications at the encoder.

Do not carry out any wiring work while encoder is live.

Never plug or unplug connector while encoder is live (the bus cover however may be removed or docked

to the basic encoder when live).

Ensure that the entire system is installed in line with EMC/EMI requirements. Operating environment and

wiring have an impact on the electromagnetic compatibility of the encoder. Install encoder and supply

cables separately or far away from sources with high emitted interference (frequency converters,

contactors, etc).

When working with consumers with high emitted interference provide separate encoder supply voltage.

Completely shield encoder housing and connecting cables.

Connect encoder to protective earth (PE) using shielded cables. The braided shield must be connected to

the cable gland or connector. Ideally, aim at dual connection to protective earth (PE), i.e. housing by

mechanical assembly and cable shield by the downstream devices. In case of earth loop problems, earth

at least on one side.

Failure to observe these instructions can result in malfunctions, material damage or personal injury!!

Baumer_PowerlinkV1-01_MA_EN.docx

19.07.2013

5/19