COMAC ABILA 52 Manual - Halaman 8

Jelajahi secara online atau unduh pdf Manual untuk Scrubber COMAC ABILA 52. COMAC ABILA 52 19 halaman. Scrubber-dryer

SQUEEGEE HEIGHT ADJUSTING

The squeegee height is to be regulated according to rubbers wearing. To adjust this:

rotate the wing nuts (1) anticlockwise to lift the squeegee and clockwise to lower it.

Note: The right and left wheels must undergo the same regulation, to allow the

squeegee to work parallel to the ground.

During the running, the back rubber is to be lightly inclined backwards (about 5 mm, on

its whole length). Should it be necessary, you can increase the rubber central inclination

by inclining backwards the squeegee body, turning the regulator anticlockwise (1). To

increase the bending of the rubber on the squeegee sides, turn the register clockwise.

Once the regulation is finished, lock the block nut.

Open the cover and check if the suction plug (2) is insert correctly and its notches are

blocked turning the plug clockwise and is well connected with the hose which leads to

the suction motor.

Furthermore check, that the squeegee hose (1) is well connected and that the exhaust

plug at the back of the machine is closed.

Fill the solution tank with clean water at a temperature not in excess of 50 ° C. Add liquid

detergent in the amounts and using the procedures recommended by the detergent

manufacturer. Use only a minimal percentage of detergent to prevent formation of an

excessive quantity of foam, as this could damage the suction motor. Close the cap.

ATTENTION! Always use low-foam detergent. Introduce a small amount

ATTENTION!

of anti-foam detergent in the recovery tank before start working, to be

sure to prevent foam formation. Never use pure acids.

MACHINE PREPARATION

Never use pure acids.

5mm