Douglas Dynamics DD 99494 Manual - Halaman 6

Jelajahi secara online atau unduh pdf Manual untuk Perlengkapan Lampu Douglas Dynamics DD 99494. Douglas Dynamics DD 99494 6 halaman. Strobe light kit stainless steel hopper spreaders

Halaman Cetak
99494

Strobe Light Operation

The strobe light comes with a pre-set fl ash pattern. In
some instances, it is possible for this default pattern
to change to a "Steady On" mode. Should this occur,
the fl ash pattern can be changed to any of 11 fl ash
patterns.
1. Cut the wire seal off the yellow wire and strip
1/4" of insulation.
2. With the strobe ON, intermittently apply 12V from
the vehicle power supply to the yellow wire until
the strobe achieves the desired fl ash pattern.
3. Reseal the yellow wire.
NOTE: The white wire is not used.
Copyright © 2020 Douglas Dynamics, LLC. All rights reserved. This material may not be reproduced or copied, in whole or in part, in any
printed, mechanical, electronic, fi lm, or other distribution and storage media, without the written consent of the company. Authorization to
photocopy items for internal or personal use by the company's outlets or spreader owner is granted.
The company reserves the right under its product improvement policy to change construction or design details and furnish equipment when
so altered without reference to illustrations or specifi cations used. This equipment manufacturer or the vehicle manufacturer may require or
recommend optional equipment for spreaders. Do not exceed vehicle ratings with a spreader. The company off ers a limited warranty for all
spreaders and accessories. See separately printed page for this important information.
Lit. No. 92945, Rev. 05
MODE
Printed in U.S.A.
6
PATTERN
0
Random
1
Steady
2
Single
3
Mega
4
Double
5
Triple
6
Quad
7
Quint
8
8 Flash
9
Single-Quad
10
Single H/L
11
Single-Triple-Quint
August 1, 2020