Douglas Dynamics SnowEx Brine Pro 2000 Manual - Halaman 8

Jelajahi secara online atau unduh pdf Manual untuk Pompa Air Douglas Dynamics SnowEx Brine Pro 2000. Douglas Dynamics SnowEx Brine Pro 2000 10 halaman. Gas engine transfer pump, brine maker

Halaman Cetak

TPS-200

8. Reinstall the pump body with the outlet ﬂ ange

facing up. Reinstall the 10 body screws, 10 lock

washers, and 10 nuts to secure the pump body to

the rear bracket. Tighten the cap screws securely

all the way around.

Reinstall the 10 body screws and secure

with 10 lock washers and 10 nuts.

9. The pump is now ready for operation.

Lit. No. 11814, Rev. 00

OPERATING INSTRUCTIONS

Gasoline is highly ﬂ ammable and gasoline

vapor is explosive. Never smoke while

working on the equipment. Keep all open

ﬂ ames away from gasoline tank and lines.

Wipe up any spilled gasoline immediately.

Do not use the pump with ﬂ ammable or

other hazardous liquids. Failure to follow

this warning may result in explosion, bodily

injury, or death. Read and follow the safety

precautions in the engine owner's manual.

Read the engine manufacturer's manual

before operating the Gas Engine Transfer

Pump.

NOTE: The gas engine is shipped without oil

in it. Do not operate the gas engine until it has

been ﬁ lled with oil. Consult the engine owner's

manual for oil speciﬁ cations and maintenance

procedures.

NOTE: To avoid premature pump seal failure,

NEVER run the pump dry. Prime and ﬁ ll the pump

with the ﬂ uid being pumped before starting the

unit.

• Ensure that hose and pipe connections are air

tight. An air leak will reduce pump capacity and

may prevent priming.

• Place the pump and engine on a level foundation,

positioned as close to the liquid tank as possible.

• Keep the suction line short and position it with few

bends.

• Install a pump strainer on the suction line when

pumping dirty water or liquids that contain solids.

WARNING

CAUTION

October 1, 2017