Doulton Ceramic Twin Undersink Panduan Pemasangan & Pemeliharaan - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pemasangan & Pemeliharaan untuk Sistem Penyaringan Air Doulton Ceramic Twin Undersink. Doulton Ceramic Twin Undersink 2 halaman.

Doulton Ceramic Twin Undersink
PLEASE READ THIS MANUAL CAREFULLY BEFORE INSTALLATION
Diagram 3 - Tube Connections
Collet
Tube
To make the connection,
1
push the tube firmly into
the connector.
5
Faucet Installation
The pure water faucet may be installed on any flat surface
over 50mm (2") in diameter. (Remember: check the
underside of the location for interference). Make a small
indent using a centre punch to mark the desired drilling
location. Drill a pilot hole with a metal drill. Enlarge the
hole using a ½" metal drill bit.
Once the hole has been drilled install the faucet as per
Diagram
4. Be sure the faucet body, chrome plate, and
the black rubber washer are placed above the sink.
Install the black locating washer, the lock washer and nut
underneath, then tighten firmly while aligning faucet in
the desired direction.
Install female Quick Fit Connector to the end of the faucet
(see
Diagram
4).
6
Activating the System for the First Time - Once all tubing has been connected, place the pure water faucet in the on
position, then open the ministop valve slowly. This will allow any trapped air to escape. Check plumbing assembly and
the undersink system are secure and free from leakage.
If there are no detected leaks, leave the pure water running for a few minutes to flush the new filter cartridges. Water
may be slightly discoloured and have some aeration, this is normal and will clear shortly.
Allow the system to stand for 2 to 3 hours and then flush again for several minutes. Your system is now operational.
Interested in Alkaline Water?
Add a AlkaHydrate Filter to your system
• Raise pH - Ideal for those who are looking to reduce acidic toxic
waste in the blood, tissues and fluids of the body.
• Add Ionic Organic, Natural Minerals
• Lower ORP (Oxygen Reduction Potential) - enhance potent anti-oxygenating qualities.
Providing great tasting pure water for over 30 years...
SHOWROOM 425 Miller Street, Cammeray NSW 2062
Tel: 02 9458 1111
Make sure the tube is
2
pushed as far as it can go
and secure with a John
Guest red clip.
SHOWROOM 342-350 Parramatta Road, Stanmore NSW 2048
Fax: 02 9458 1199
Tel: 02 9562 0777
www.watershop.com.au
Red Clip
Diagram 4 - Your choice of designer faucet
Mounting Plate
Black Locating
Washer
To remove the tube - first, remove
3
the red clip and then use two fingers
to push onto the collet and at the
same time pull out the tube.
Chrome
Faucet
Lock Washer
Red Clip
Blue 1/4" Tube
Black Rubber
Washer OR O-ring
Benchtop
Nut
Quick Fit
Connector to
Blue 1/4" Tube