Asus AP1600R Panduan Pengguna - Halaman 26

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Server Asus AP1600R. Asus AP1600R 48 halaman. Dual intel xeon 1u rackmount server

2.5 Installing the backplane and bridge boards

2.5.1 Bridge board (BRIDGE-AR12)

The bridge board links several functions and signals from the motherboard

to the backplane board. The board connects to the pair of connectors labeled

BPCON on the motherboard and to another pair on the backplane. Four

screws secure the bridge board to the motherboard and backplane (indicated

by circles in the figure below).

Connectors for

the motherboard

Connectors for

the backplane

2.5.2 Bridge board (BRIDGE/S-AR12)

If you installed a SCSI RAID card, you may create a RAID configuration

using the bundled bridge board for SCSI (BRIDGE/S-AR12).

1. Remove the metal metal cage over the bridge board. See instructions

on removing the metal cage on page 38 (PCI fan section).

2. Remove the standard bridge board (BRIDGE-AR12) and replace it with

the SCSI bridge board (BRIDGE/S-AR12).

3. Install the bridge board with the 68-pin SCSI connector facing the rear

panel (see picture on the next page). Take note of the BPCON

connectors for the motherboard (MB) and the backplane (BP).

4. Secure the bridge board with four screws.

5. Connect a 68-pin SCSI cable from the SCSI RAID card to the SCSI

connector on the bridge board.

(BRIDGE-AR12)

Chapter 2: Hardware Setup