Dove TechMaster Panduan Pemilik - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Mixer Musik Dove TechMaster. Dove TechMaster 7 halaman. Control console

RECEIVING YOUR EQUIPMENT

As soon as you have received your equipment, open the boxes and examine the contents. If the

equipment in the carton does not agree with your order or the packing slip, contact the factory imme-

diately and we will be happy to help you. If any damage is noted, contact the carrier immediately to

file a claim for damages. You can be sure that when the equipment left the factory it was in good con-

dition, thoroughly tested, and properly packed.

The TechMaster is a lighting control console with standard DMX-512 output. The console is arranged

in standard two scene configuration with a switch to single scene mode. A special hold mode button

adds a virtual second scene to single scene mode. The console includes a grandmaster slider, black-

out button, split dipless crossfaders and programmable chase.

Proper connection of electronic lighting control equipment is

very important. The TechMaster has been designed to make it

as simple as possible. The TechMaster must be connected to

the dimmer pack through a control cable. The cable uses five

pin XLR connectors for standard DMX control. The connectors

are wired according to the diagram at right.

Plug the male end of the control cable into the female connector

on the TechMaster. Plug the female end of the control cable into

the dimmer pack.

Adjust the grandmaster control to full (up position), both cross-

faders to the up position, and the SS/2S switch to the 2S (2

scene) position. Plug the power supply ("wall wart") into the

console and a wall outlet. As the channel one, scene X (top left

channel control) is adjusted up, the instrument plugged into dim-

mer one should come up. If not, refer to the Troubleshooting

section.

The console is arranged in standard two scene configuration. The term "two scene" refers to an ar-

rangement in which light levels for the next look are preset without affecting the look presently on

stage. At the appropriate time the board operator crossfades from the look on stage to the preset

look.