Amphenol SSI Digital Fluid-Trac DFT-200 Series Panduan Pemecahan Masalah - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pemecahan Masalah untuk Aksesori Amphenol SSI Digital Fluid-Trac DFT-200 Series. Amphenol SSI Digital Fluid-Trac DFT-200 Series 4 halaman.
Halaman Cetak
Simulate an Empty (0 gallons / 4 mA) Reading
a) Place the Digital Fluid-Trac
the table top.
b) Press the Refresh/Select button.
c) The display should read approximately 0 gallons or 4 mA, depending on output type.
7. For DFT 200 series only (DFT-200, DFT-210, DFT-220)
Simulate a Full (55 gallons / 20 mA) Reading
a) If cable is connected in back of unit, but backlight is off, it indicates loss of power or ground
from power supply. Display may have erroneous reading during this condition.
b) When using batteries "REFRESH/SELECT" button must be pushed to update unit to current
barrel level reading.
Copyright © 2019, SSI Technologies, LLC
32 inches above the table top. Make sure the sensor is level with
®
3
Doc. DT-AN4 — Rev. 01
ssi-sensors.com