Amphenol nrgSMART SENS Panduan Konfigurasi Sistem - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Konfigurasi Sistem untuk Pengontrol Amphenol nrgSMART SENS. Amphenol nrgSMART SENS 11 halaman. Integrated controller
Halaman Cetak
h. Change your setting from Obtain an IP Address Automatically to Use the Following IP
Address. In the subnet range of 169.254.xxx.xxx, you must increment the last octet(3 digits)
by 1 from what is displayed in the LCD screen of the controller; no gateway or DNS needed.
i.
Hit OK on the next two screens to complete the change.
j.
Connect to nrgSMART Controller via a browser by typing its IP address of 169.254.xxx.xxx
Note: Chrome and Firefox are recommended.
k. The Configuration webpage will be displayed
3. The controller can be operated in the following modes simultaneously:
HTML User Interface Mode:
•
The controller will present data from all panel sensors within the panel itself, and from any
nrgSMART SENS panels that are connected to it over the nrgNET serial interface.
•
Summary data from the Controller can be viewed from the controller's front LCD screen. It will
scroll through the following parameters. (If additional nrgSMART SENS panels are connected to
the controller, their data will not be shown on the display, other than the "number of active panels"
this will reflect how many panels are being monitored by the controller.).
o Integrated Controller Name
o nrgOS version
o Number of active panels
o IP address
o Integrated Panel name
o Integrated Panel serial number
o Feed Current A and B
o Feed Voltage A and B
o Temperature 1 and 2
•
The Integrated Controller will indicate alarms by flashing between white and black backgrounds.
When in alarm, a bell symbol will be displayed next to the Integrated Controller Name. If the alarm
is from the Integrated Panel, a bell will also be displayed next to the value in alarm. For example, if
Temperature 1 of the Controller Panel is in alarm, there will be a bell symbol next to the "Temp 1"
on the display.
•
Note that if an interconnected nrgSMART SENS panel is in alarm, the Controller display will flash,
however, the Controller will not indicate which interconnected nrgSMART SENS panel is in alarm.
You will need to check the front panel LEDs of the interconnected SENS panels (locally), or connect
to the Controller's HTML User Interface, or your NMS system, to determine which panel is in alarm,
and what the specific alarm condition is.
SNMP Mode:
•
The LAN port must be connected and configured to operate on the same subnet as the customer
defined Simple Network Management Protocol (SNMP)/ Network Management Server (NMS)
server address.
•
The nrgSMART Management Information Base (MIB) table is available for download at the
following URL:
nrgSMART Integrated Controller
https://amphenol-ns.com/Product/nrgsmart-controller
All rights reserved. 4.16.2021 151881 A0
8
Amphenol Network Solutions
509.926.6000 — amphenol-ns.com