Comax CM-PIR03 Panduan Pengoperasian

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Aksesori Comax CM-PIR03. Comax CM-PIR03 2 halaman. Wireless pir motion sensor

Halaman Cetak
Introduction
Thanks for choosing the Comax's wireless PIR motion sensor
TM
Wave
enabled device (interoperable, two
enabled device (interoperable, two-way RF mesh networking technology) and is fully compatible with any
TM
Z-Wave
enabled network. Every main
devices result in more possible transmission routes which helps eliminate "RF dead-spots".
devices result in more possible transmissi
TM
Z-Wave
enabled device displaying the Z
enabled device displaying the Z-Wave
and ours can also be used in other manufacturer's Z
and ours can also be used in other manufacturer's Z -Wave
TM
and send Z-Wave
signal when movement is detected inside the building
signal when movement is detected inside the building

Product Description

Specification:
Installation
1.
Open the cover and insert battery into the battery compartment, LED will start to flash slowly.
2.
Close the back cover.
To add the sensor, Put the Z-Wave
CM-PIR03 to your controller. Press the program switch of
stop flashing, if not, please try again.
stop flashing, if not, please try again.
To Delete the sensor from network,
instruction to delete the CM-PIR03
deleted. The LED
3.
Mount the sensor at 2 meters above surface. To enhance proper operation, place
can detect the room widely.
Operation Manual
Wireless PIR Motion Sensor
CM-PIR03
wireless PIR motion sensor for the home security device. This sensor is a Z
way RF mesh networking technology) and is fully compatible with any
main powered Z-Wave
TM
Protocol: Z-Wave
Wave
Frequency Range:
Frequency Range: 868.4MHz
Operating Range: Up to 50M line of sight
Operating Range: Up to 50M
Operating Temp.: -10°C to 50°C
Operating Temp.:
Battery: CR123A
Battery: CR123A -1pcs
nsert battery into the battery compartment, LED will start to flash slowly.
nsert battery into the battery compartment, LED will start to flash slowly.
Wave Interface Controller into "add" mode, and follow instruction
. Press the program switch of CM-PIR03 once. The LED on the
from network, Put the Z-Wave Interface Controller into "delete" mode, and follow
PIR03 to your controller. Press the program switch of sensor
on the sensor
sensor should start to flash.
at 2 meters above surface. To enhance proper operation, place sensor
the home security device. This sensor is a Z-
TM
enabled device acts as a signal repeater and multiple
enabled device acts as a signal repeater and multiple
logo can also be used with it regardless of the manufacturer,
logo can also be used with it regardless of the manufacturer,
TM
enabled networks. This sensor monitors movement,
enabled networks. This sensor mon
.
,
865.2MHz
once. The LED on the sensor should
instruction to add the
delete" mode, and follow
sensor once to be
on the angle which