Dover Triton 9600 Manual Konversi - Halaman 3

Jelajahi secara online atau unduh pdf Manual Konversi untuk Peralatan Industri Dover Triton 9600. Dover Triton 9600 4 halaman.
Juga untuk Dover Triton 9600: Prosedur Konversi (10 halaman)

Halaman Cetak

9600-TO-9610 CONVERSION GUIDE

After routing the cable, close the power supply panel

and tighten the mounting screws securely. Be sure

to remove the old DC power cable from the cabinet.

Route end of cable through hole

in the cabinet

7. Set the 9610 dispenser onto the tray. Turn the

dispenser so that the rear of the unit (where the

power and data cable connectors are located) may

be accessed.

8. Plug the EJ-to-Dispenser (Data) cable into the rear

connector of the EJ. Make sure the thumbscrews

on the EJ-to-Dispenser cable are tightened.

Route the end of the EJ-to-Dispenser cable down

through the cutout in the rear of the right rail bracket

and let the free end hang beneath the bracket.

EJ-to-Dispenser Cable.

TRITON SYSTEMS, INC.

9. Plug the DC Power Cable AND the existing EJ-to-

Dispenser cable into the mating connectors located

on the back of the dispenser. NOTE: Make sure

the white strain clip on the DC Power Cable is

pointing down. Make sure the thumbscrews on

the EJ-to-Dispenser cable are tightened.

9610 DC

Power Cable

Make sure the connector

on the dispenser DC

Power cable is

positioned as shown.

10. Turn the dispenser around with the cables facing

the back of the cabinet and align the tabs and holes

in the bottom of the dispenser with the mounting

holes in the tray. Attach the dispenser to the tray

using the four (4) included 3/8-inch (9 mm) Pan Head

Phillips Screws (two on each side).

Attach the dispenser to the tray with two screws on

each side.

EJ-to-Dispenser

Cable.