Dover HYDRO EvoWash Panduan Memulai Cepat - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Dispenser Dover HYDRO EvoWash. Dover HYDRO EvoWash 19 halaman.
Halaman Cetak
operation
Controls
There are three control keys below the EvoWash display:
•
Next: the "right arrow" that moves to the next item.
•
Scroll: the "up arrow" that changes a value.
•
Enter: the "down and over arrow" to make a selection.
User Mode
"User mode" is the default mode which the end user will be able to view and operate. The schematic and descriptions below
detail the use of the User Mode menu screens.
The unit cannot be programmed in User Mode, go to the 'Programming Mode" section to program the unit.
From the Home Screen, press the Next key to access and move through the user mode's menu loop. After 30 seconds of
inactivity, the unit will automatically return to the Home Screen.
User Mode Menus
From an "idle" display, either the Home Screen or the live
conductivity display if enabled, you press the Next key to
move through the User Mode menus. The menu structure
is shown to the right.
NOTE: If enabled, the live Conductivity display can be used
in place of the normal Idle Home Screen display.
Below are examples of other displays you might see on the
Home Screen, showing various signals, activities or errors.
Idle Home Screen
0 0 0
—
Rinse Signal On
000
—
Rinse Pump On
00
—
Low Detergent Alarm
0 0 0
—
NOTE: Black indicates LED segments on constantly.
Gray indicates LED segments blinking on and off.
The gradient indicates a rotating zero digit (
8
Probe Mode Active
000
—
Detergent Signal On
000
—
Detergent Feed On
0 0
—
Detergent Overfeed Stop
0 0
0 0 0
—
—
0
).
000
Next
Scroll
Idle Home Screen
0 0 0
—
No menu activity for 30 seconds
returns to the Idle Home Screen
Rack Count Menu
0001 1
7
000
0001
Max Detergent Time
000
Detergent Prime
000
2 1
000
Rinse Prime
000
3 1
000
De-Scale Menu
De-Scaling Countdown
000
4 1
600
Live Conductivity Display (If enabled)
000
1
4 0
Enter
Tens of Racks
2 3
RAM Check
Press Enter
to Reset
Checksum
Press Enter
to Reset
MaxDetTime
Detergent Feed On
Rinse Pump On