Ample Scientific Champion E-33 Series Manual
Jelajahi secara online atau unduh pdf Manual untuk Peralatan Laboratorium Ample Scientific Champion E-33 Series. Ample Scientific Champion E-33 Series 4 halaman.
Halaman Cetak
1. Introduction
Thank you for choosing Champion E-33 Series centrifuge from Ample
Scientific. Champion E-33 Series features:
Economical and competitive price
Temperature controlled motor to extend centrifuge life expectancy
Well balanced system minimizing vibration and maximize operation
safety
Portable design with its lightweight and durable structure
2. Product Structure
Lid Lock
LED Power Display
Timer
Figure 1 - Product External Structure
Pg | 1
Lid
45˚ Angled
PC Rotor
3. Installation and Setup
1. Inspect the centrifuge for any damages. Contact distributor for
questions regarding damages.
2. Place centrifuge on steady and leveled surface. The area should be
well ventilated, and the centrifuge should be kept at least 300mm
away from surrounding objects in all directions. Champion E-33
Series is for indoor use only.
3. Verify that there are no loose pieces or packing material in the
centrifuge chamber.
4. Before centrifuging, test tubes need to be tightly sealed then placed
into rotor buckets. Do not use buckets from another manufacturer.
5. Make sure the loads are balanced before centrifugation. Make sure
that test tubes opposite of each other are of equal weight and size.
Use sample fluid or water to provide balance. Proper sample
balancing will improve sample separation and will extend the life of
the centrifuge. Glass test tubes are more likely to break if the
sample loads are unbalanced. Please
according to the following configurations:
Figure 2 - Sample Balancing Diagram
6. Verify that the power switch is off and the timer is set at 0. Connect
the power cord to an appropriate power supply. (see back of
centrifuge for appropriate power source)
7. Turn on the centrifuge. Make sure there is little to no vibration and
the whirring sound produced is smooth. If there are excessive
vibration or abnormal sounds, stop the centrifuge and contact
distributor immediately.
install tubes into rotor
Pg | 2